The Concrete Surface Mounted Strain Gauge is used for measuring strain in concrete structures including load bearing concrete beams and piles.
The Concrete Surface Mount Strain Gauge measures strain in concrete members. It consists of a coil assembly, Vibrating Wire element and two groutable anchors to embed the unit in the concrete structure to be monitored. O-ring seals between the protective tube and the gauge end blocks provide waterprooﬁng and allow the tube to remain unstressed.
A factory ﬁtted, four-core screened cable connects the coil to the readout unit. Once installed, changes in strain are monitored by the coil assembly mounted on the gauge. The gauges can be read individually and locally, or remotely and automatically as part of a data collection system.
- Adjustable strain gauge for the most eﬀective use of the instrument range
- Individually calibrated
- Integral thermistor
- Gauge and coils are re-useable
- Over 30 years of expertise in the design and manufacture of Vibrating Wire instrument technology
- Accurate, repeatable readings over long cable lengths
- Long working life, long term stability and reliability
- Can be used with long cable lengths with no degradation of signal
- Suitable for remote reading and data logging
The Concrete Surface Mount Strain Gauge consists of a sealed tube containing the wire that is attached via allen bolts to a removable anchor at either end.
The pickup coil is designed to slip easily over a flattened section in the centre of the gauge tube, so it can also be fitted after installing the gauge. As the gauge and the coil are easily removable, they can be reused if desired.
The anchor bolts are site grouted using the setting bar as a template to drill holes into the structure to be monitored.The gauge must be removed from the anchor bolts during grouting to prevent damaging it. The two anchor bolts are grouted (using the gauge setting bar as a template) on to the structure to be monitored. Once the anchors have been grouted into the holes, the gauge is refitted into the anchors and tensioned as necessary. If not already fitted, the pickup coil needs to be slid into place and secured with cable ties.
The sensor can be read using any commercially available Vibrating Wire readout, and temperature data can also be read from the integral thermistor. The use of a frequency based signal (as with all VW measurements) means long cable runs are achievable (in excess of 1,000m) between the instrument and the readout point or data logger.
The Concrete Surface Mounted Strain Gauge can measure strain on concrete members on buildings, bridges, dams, pipelines or any other concrete structure.
Typical applications include:
- Concrete members and struts
- Monitoring of strain due to load
- Bridges and dams
- Monitoring strain and load during construction and service life
- Piles and mass concrete.